Dan-dugan-sound-design E-2 Bedienungsanleitung PDF herunterladen (Seite 22)

Dugan Model E-2 User Guide

Linking

Up to eight Dugan units can be linked into a single automatic mixing system. The

audio I/O for each must be configured and connected individually. Linking passes

only control information between Dugans, not audio.

One unit must be set to be the master and the others slaves.

1. Designate one unit as the master by setting the NORM–SLAVE switch on the rear

panel to NORM (up).

2. Designate any other units as slaves by setting their NORM–SLAVE switches on the

rear panel to SLAVE (down).

3. Use ADAT (Toslink) cables to link units in a ring network (see above).

Note that all LINK IN and OUT connectors are used to create the ring.

Figure 3-3 Linking Dugan units

Patching the Model E-2 as an Insert to your Console

The best place to insert the

• Dugan Speech System channels is post-EQ, post-fader, pre-compressor;

• Dugan Music System channels is post-EQ, pre-fader, pre-compressor.

Unprocessed Outputs

When using the ANA setting, the ADAT AUD OUT connector can send unprocessed sig-

nals (channels 1–8) to a multitrack recorder.

When using the DIGI setting, the AUDIO I/O 1–4 and AUDIO I/O 5–8 connectors can send

unprocessed signals (channels 1–8) to a multitrack recorder.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Keine Kommentare

Dan-dugan-sound-design E-2 Bedienungsanleitung Seite 22