Dan-dugan-sound-design E-1 Bedienungsanleitung PDF herunterladen (Seite 20)

Dugan Models E-1 and E-1A User Guide

3. Use ADAT (Toslink) cables to link units in a ring network (see below).

Note that all LINK IN and OUT connectors are used to create the ring.

NOTE: Due to the Model E-1A’s compact size and close spacing of the ADAT connectors, some large

cables may not fit. The maximum cable width is 0.48 in (12 mm).

NOTE: Linked Model E-1s appear in group a only. Linked Model E-1As can use groups a–c.

Configuration

Power-up Commands

The Model E-1A can execute one of five commands during each power-up. Select the

command by holding down a specific button during the entire power-up process,

which takes just a few seconds. Power-up is complete after the LEDs stop flashing.

To execute more than one command, turn the unit off after it finishes powering up,

and repeat for the next command.

Table 3-1 Power-up commands

*These buttons perform startup commands on the Model E, not the Model E-1A

Reset

Hold down the channel 1 bypass button to set all parameters to factory default set-

tings and clear label text. We recommend executing this command (just like “zeroing

out” a console) before starting a new installation.

channel 1 channel 2 channel 3* channel 4

bypass

System Reset DHCP On N/A 16 channel mode

mute

Network Reset N/A N/A 8 channel mode

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Keine Kommentare

Dan-dugan-sound-design E-1 Bedienungsanleitung Seite 20