Dan-dugan-sound-design E Bedienungsanleitung PDF herunterladen (Seite 9)

Dugan Model E User Guide

Chapter 2: Quickstart

This section provides step-by-step instructions to help you get started quickly. It includes

information to connect and install the Model E, make initial settings, and link units.

Step 1 Connections

Connect the provided power supply to the Model E.

Set the NORM-SLAVE switch on the rear panel to NORM (up) for normal (not linked)

operation.

The Model E can be interfaced with:

• an analog mixing board;

• a digital mixing board using analog or digital connections;

Analog

The Model E is a line-level device normally patched into the insert jacks (send and re-

turn) for each mic input channel on the board. Check the insert jack wiring on your mix-

ing board. If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS

insert cables to connect the Model E. Other configurations require special cables. The

Model E is wired as follows: tip = input, ring = output.

Figure 2-1 Analog connection

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Keine Kommentare

Dan-dugan-sound-design E Bedienungsanleitung Seite 9